“A brief weaving lesson”
According to the demands of our customers we use every weavable metal and synthetic wires with diameters ranging from 0,018 mm up to 5 mm.
Mesh size / Fineness of filtration:
Mesh size (aperture) of wire cloth between 0,02 mm and 20,0 mm (woven wire mesh) and 6 – 200 mm (crimped wire mesh)
Dutch weave with a fineness of filtration of 5 μm to 350 μm
Width of wire mesh rolls:
8 mm — 3.400 mm
This results in a wide range of different mesh types, which is topped off by the offer of custom-made products for our clients.
Binding types
- THE PLAIN WEAVE / SQUARE MESH
The Plain Weave / Square Mesh is characterized by extremely precise mesh sizes. Weft wires are wound over and under the warp wires alternately in a constant pattern. The characteristics of this weave can be modified for special requirements. - RECTANGULAR MESH – OBLONG / BROAD
The most common mesh ratio is 1 : 3 and if the ratio is reversed, the mesh is known as broad mesh. This mesh is, for example, used for vibrating sieving screens. - TWILLED WEAVE
This type of weave is suitable where there is a need for relatively small mesh sizes and strong wires. The special form of herringbone twill was created to compensate for the diagonal movement of the weave. Suitable as a lining weave. - TWILLED WEAVE, 5-BONDED
A special weave type for drain filters with good flow rate. Every fifth wire goes over and under alternately and creates a smooth surface on one side. This weave type has the advantage of being quick and easy to clean. - PLAIN DUTCH WEAVE
The warp wires in this weave are always stronger than the weft wires. The so called “zero mesh” is created by positioning the weft wires as closely together as possible. The specific benefits are good flow rate and even openings. - DUTCH TWILLED WEAVE
This process involves forcing the weft wires together during weaving. This kind of mesh has double the number of weft wires compared with the plain Dutch weave, providing a particularly smooth surface for ultra-fine filtration. - REVERSE DUTCH WEAVE
The weft wires are significantly thicker than the warp wires. As the bulk of the wires are located in the warp, this weave type is often referred to as the reverse of plain Dutch weave. This weave is characterized by good stability and flow rate. - WAVE GRID WIRE MESH FORM C
Crimped wires are used in both directions and combined to create a robust wire screen with a stable form and surface. Suitable as protective screens for fences, gates and partitions for rack shelving systems. We manufacture this mesh types as wave grid (form C) or crimped (form D) - CRIMPED WIRE MESH FORM D / D
Our crimped mesh form D / D fulfil highest standard in terms of quality and stability. Only with modern machines wires with the diameter of 5 mm can be weaved faultlessly. For the manufacturing steel wires are pre-crimped. Due this profile the wires can be weaved (without welding) as a very robust mesh. There is a range of mesh with aperture 6 up to 100 mm. Wire thickness is up to Ø 5 mm. Crimped wire mesh is mainly used for protection safety guards, gates but also tin terms of baskets (heat-treatment, galvanizing, etc.) - CRIMPED WIRE MESH FORM E
Like Form D / D , with the difference that crossing points of warp and weft wires lie in plane position at the intersection points. This formation generates grid with one plane bottom side. - WELDED SCREENS
Similar to reinforced meshes, the horizontal wires (roll width) joined together with vertical wires (roll length) by spot welding. These constant connection points ensure a high performance stability.
